This can be solved by straightening a length of craft wire by pulling both ends of the wire with pliers and trimming two 1″ sections that are then soldered in place. Now, you might have noticed that there are two gaps in the layer of the positive leads. Solder all of the positive leads together and trim off the access of the leads. The red arrows represent the positives(anodes) likewise the blue arrows represent the negatives(cathodes). This may sound tedious but in the end this will safe-guard your your project! Next, insert 16 LEDs into the holes and bend the leads to the direction of the arrows using needle nose pliers. Take the 64 LEDs and test them to ensure that they all work using a button cell battery.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |